Now test by digitizing some of the features of the map into AutoCAD. For this to work the tablet must first be configured such that the entire limits is considered to be the drawing area. When prompted for the coordinates type 310,397.
When next prompted to pick the upper right hand corner click on the pencil dot. When prompted for the coordinates type 100,100. Now calibrate the digitizer and when asked to pick the lower left hand corner click on the pencil dot.
#Wintab digitizer software for autocad driver#
This driver has all the features of wintab except for screen mapping which most digitizing software does not need. You can further limit AutoCAD to use only the Wintab Compatible Digitizer.
See the section 'Adjusting the AutoCAD 3D Graphics System' later in this. Secure the map to the digitizer with tape making sure that the section of the map you are about to digitize falls within the limits of the digitizing area. Only Wintab-compatible digitizers are supported with AutoCAD for digitizer tablets. Now take a pencil and put a dot on the map just outside the lower left hand corner of the paper and the upper right hand corner of the paper. You can directly digitize the sequence of events and generate cut quality DXF files. In the selection list Current Pointing Device select WinTab Compatible Digitizer ADI 4.2. You can input or measure a shrinkage/scale factor to allow for deterioration of templates. You can reset the origin, allowing digitizing of shapes much bigger than the digitizer surface 2. Take an A4 size piece of paper and lay it on the map. There are additional functions of great value: 1.
Yes but my friend wants to use tablet for that, he set draw on table and then with polylines digitize drowing in AutoCad, just we cannot set some calibrations good
0 kommentar(er)
